A Few Tips And Tricks About Hard Drive Diagnostics 

Hard drive diagnostic explained

Hard drive temperature. The hard drive temperature is a very important factor. The hotter the hard drive is, the bigger the probability it is for it to fail. The conclusion from many cases of faulty hard drives that we had to replace in the past was primarily based on its temperature.

The temperature can be easily checked with the same tool I usually use, a favorite of mine, the GSmartControl tool.

Tell me about your problem by clicking here. I will reply in two hours with a solution.

HDTune has a capability to display the hard drive temperature.

There are also other good programs out there that display the hard disk temperature such as the CPU ID Hardware Monitor, Hiren’s boot CD, etc.  There is even a Windows widget for it. It is very important that the hard drive temperature be less than 50 degree Celsius.

If the temperature is more than this, the disk starts to deform, and during this deformation, damage can occur on the disk surface.

Sound from the hard drive. Clicking from the hard drive can mean many things. But most likely, this clicking is a head failure and the hard drive is not able to read the system area information from the disk. In this case, a clicking is heard, or the hard drive attempts to read one area, and after many attempts, it will just power off.

Benchmark. There is a lot of software that is able to do hard disk benchmarking. I use HDTune’s disk surface scan for this.

When it scans the surface, it will show the reading speed. If this speed varies significantly, such as from 10 MB/s to 60 MB/s, this indicates that a problem is evident in the hard disk hardwire. This usually relates to the head or preamplifier.

HDTune also has a benchmarking feature. This remedy is good for someone who has the time to complete the test, but for computer repair businesses, this remedy simply takes too much time.

Programs that are used for hard drive diagnostics.
The best software tool that I have used is the GSmartControl tool. There are just a few values that need to be paid attention to.

It's Raw Error Rate. This is the value I always check. On Seagate hard drives, this value can get very big. 

Reallocation even count. This indicates that the hard drive has relocated, or that there is a bad sector and the value has been recorded to the G-List. If checked with HDTune, it will not show anything bad until the threshold value has been reached. This is important as the threshold is the limit to when the hard drive can still manage bad sectors.

Current Pending Sector Count. Personally, I do not like any numbers here. As described in S.M.A.R.T., this is something can change values depending if the sector can be read or not.

Reallocated sector count. This is a real value that shows how many sectors have been relocated.

HDTune informs us if the hard drive is okay or not.

Back to Home

What is the Difference Between SATA and ATA (Older) Hard Drives

How to Recover Data from External Hard Drive

What are Differences Between HDD, SSHD and SSD

What Do You Want To Read Next. Write Me A Message.

Tell Me About Your Problem By Clicking Here. I Will Reply In Two Hours With A Solution.
We Sell Windows 10 Home and Pro 32/64 bit Factory Reset, Reinstall, and Restore USB Flash Drives For Laptops And Desktop Computers.

Kindle book
Leave me a comment in the box below.

Tell Me Your Problem Here
Laptop RAM
PC motherboard
Gaming laptop
Dell laptop
Metcal soldering station

Reach Me on your phone browser using QR code below

Bar code WWW address